Another spun rod bearing [message #371311] |
Sat, 06 May 2023 18:52 |
bwevers
Messages: 597 Registered: October 2010 Location: San Jose
Karma:
|
Senior Member |
|
|
I'm at a loss to figure out why this happened again. My 455 spun the #7 rod bearing while cruising on Interstate 5 near Los Banos. This engine had more than 10,000 miles on it since the last rebuild. The crankshaft was turned .010/.010" by a reputable shop. And this engine had previously spun the same rod bearing 7 years ago. It has a high-volume oil pump. I had changed the oil within the last 3000 miles. The oil pressure was good, 40 PSI hot. Usually I get 60 PSI cold oil pressure, using 15W/40 Delo. I'm thinking maybe the rod bearing clearance was too tight.
Bill Wevers GMC49ers, GMC Western States
1975 Glenbrook - Manny Powerdrive, OneTon
455 F Block, G heads
San Jose
|
|
|