5 Volts Bleeding to Opposite Turn Signal [message #370971] |
Tue, 10 January 2023 16:01 |
Tom Katzenberger
Messages: 399 Registered: June 2019 Location: Kingsville, MD
Karma:
|
Senior Member |
|
|
Hello all,
I am installing a LED light bar across the rear scooter carrier. I am trying to defend myself, as much as possible, against those who text and drive, (i.e. rear end collision).
There is a blead of 5 volts which strays to the opposite signal. Not enough to fully light the filaments in the original bulbs, but plenty to light the light bar.
I was thinking Diode but I don't even know where the current would be crossing. Therefore I don't even now where to put the Diode. Has anyone else come across this problem? If so any tips and tricks would be welcome.
Thanks to all and have a great evening.
Take care,
Tom K.
Tom & Oki Katzenberger,
Kingsville, Maryland,
1977 23' Birchaven, 455 C.I.D., Micro Level, Howell EBL-EFI Spark Control, Macerator, York Air Compressor, 6 Wheel Disc, Quadra Bag, Onan W/Bovee Ignition
|
|
|