Help [message #349865] |
Mon, 04 November 2019 13:46 |
jhbridges
Messages: 8412 Registered: May 2011 Location: Braselton ga
Karma:
|
Senior Member |
|
|
My front brakes leak the MC down. So, off they come. Is it possible to get the upper caliper pin on the passenger side out without taking the upoper ball joint loose and raising the upper control arm? So far I haven't been able to jack it to a position where this can be done. On the driver's side, the upper pin barely came out, but had enough wiggle to lean and come out. Ideas befor I go find my ball joint fork? I DON'T wanna disassemble it if I don't haveto.
A look at the drivers side caliper with torn seals, corroded piston etc. Tells me this side is likely no better. It was due for front brakes anyhow.
--johnny
Foolish Carriage, 76 26' Eleganza(?) with beaucoup mods and add - ons.
Braselton, Ga.
I forgive them all, save those who hurt the dogs. They must answer to me in hell
|
|
|