Brake work - caliper caution [message #349783] |
Fri, 01 November 2019 11:02 |
|
Matt Colie
Messages: 8547 Registered: March 2007 Location: S.E. Michigan
Karma:
|
Senior Member |
|
|
I have recently torn down a friends master cylinder to find it not damaged, but full of foreign material in the high pressure seals.
Because I am working to make a 95 Accord safe to drive again, I was watching YouTubes about front bearings. (The bearing has failed and so damaged one brake.)
In the section I was watching, the technician demonstrated that he always clamps off the line to the caliper and vents the fluid out the bleeder. As Greg's coach recently had front brake work and then the master cylinder failed (I mean failed big time - peddle to the floor, but no fluid lost!) I am willing to accept this as a cause.
When I come up for air, I plan to rebuild the good casting and put it on the shelf.
Matt - Break is over, back on my head
Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit
|
|
|