GMCforum: GMCnet » In-Tank Fuel Pump Wiring

Home » Public Forums » GMCnet » In-Tank Fuel Pump Wiring

Show: Today's Messages :: Polls :: Message Navigator

In-Tank Fuel Pump Wiring [message #248904]

Wed, 30 April 2014 15:24

Jon payne

Messages: 495
Registered: May 2008

Karma:

Senior Member

Guys,

I'm wiring up my in-tank fuel pumps I got from Applied. The leads on the pump are not long enough to reach the base of the fuel sender so I have to extend the leads. At first I was going to use the wire I have but the coating is PVC which I believe will not tolerate being submerged in fuel. I do have some PTFE wire, left over from an aircraft wiring mod, but I think it is only 22 gauge. Searching the innerweb I see all kinds of opinions on what kind of wire to use, some say PVC is fine others say it is not. I have read PVC is fuel resistant but not necessarily made for submersion.

Looking for some opinions/advice on what to do for the in-tank wiring.

Jon

Jon Payne
76 Palm Beach
Westfield,IN

Report message to a moderator

[Message index]

In-Tank Fuel Pump Wiring

By: Jon payne on Wed, 30 April 2014 15:24

Previous Topic:	What Did I Find in the Bottom of My Oil Pan
Next Topic:	[GMCnet] Info for Mike and other GMCMI members

Goto Forum:

-=] Back to Top [=-

Current Time: Tue Nov 19 17:27:59 CST 2024

Total time taken to generate the page: 0.00846 seconds