Home » Public Forums » GMCnet » [GMCnet] Re: Olds 455 donor engine
[GMCnet] Re: Olds 455 donor engine [message #369908] |
Thu, 09 June 2022 09:51 |
James Hupy
Messages: 6806 Registered: May 2010
Karma: -62
|
Senior Member |
|
|
Yes, the cam gallery plug on the rear of the block. It has a lube hole to
lube the distributor drive gear. Specific to the 455.
Jim Hupy
Salem, Oregon
On Thu, Jun 9, 2022, 7:48 AM Keith V wrote:
> I have a non Toro 455 with a bad block, the cly bores are very rusted, it
> would need to be sleaved.
> it has c heads, not sure if it has the good valve covers, not a Toro
> intake, crank may be OK
>
> I'm planning on selling the heads and valve covers unless they are the
> good one and scrapping the rest
>
> is there anything else I should salvage?
>
> Keith Vasilakes
> Mounds View MN
> 76 exRoyale
> MicroLevel http://www.gmcmotorhomemarketplace.com/vasilakes/microlevel_intro.pdf>
>
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
|
|
|
[GMCnet] Re: Olds 455 donor engine [message #369909 is a reply to message #369908] |
Thu, 09 June 2022 12:02 |
jimk
Messages: 6734 Registered: July 2006 Location: Belmont, CA
Karma: 9
|
Senior Member |
|
|
Valve covers are valuable, intake manifold,
Jim Kanomata ASE
Applied GMC RV
On Thu, Jun 9, 2022 at 7:52 AM James Hupy wrote:
> Yes, the cam gallery plug on the rear of the block. It has a lube hole to
> lube the distributor drive gear. Specific to the 455.
> Jim Hupy
> Salem, Oregon
>
> On Thu, Jun 9, 2022, 7:48 AM Keith V wrote:
>
>> I have a non Toro 455 with a bad block, the cly bores are very rusted, it
>> would need to be sleaved.
>> it has c heads, not sure if it has the good valve covers, not a Toro
>> intake, crank may be OK
>>
>> I'm planning on selling the heads and valve covers unless they are the
>> good one and scrapping the rest
>>
>> is there anything else I should salvage?
>>
>> Keith Vasilakes
>> Mounds View MN
>> 76 exRoyale
>> MicroLevel> http://www.gmcmotorhomemarketplace.com/vasilakes/microlevel_intro.pdf>
>>
>>
>> _______________________________________________
>> GMCnet mailing list
>> Unsubscribe or Change List Options:
>>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
>
--
Jim Kanomata ASE
Applied/GMC, Newark,CA
jimk@appliedairfilters.com
http://www.gmcrvparts.com
1-800-752-7502
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
Jim Kanomata
Applied/GMC
jimk@appliedairfilters.com
www.appliedgmc.com
1-800-752-7502
|
|
|
[GMCnet] Re: Olds 455 donor engine [message #369963 is a reply to message #369909] |
Wed, 15 June 2022 16:55 |
Bruce Hart
Messages: 1501 Registered: October 2011 Location: La Grange, Wyoming
Karma: 5
|
Senior Member |
|
|
If it is a non Toro and not from a GMC isn't the starter mounted on the
driver's side?
On Thu, Jun 9, 2022 at 11:02 AM Jim Kanomata wrote:
> Valve covers are valuable, intake manifold,
> Jim Kanomata ASE
> Applied GMC RV
>
>
> On Thu, Jun 9, 2022 at 7:52 AM James Hupy wrote:
>
>> Yes, the cam gallery plug on the rear of the block. It has a lube hole to
>> lube the distributor drive gear. Specific to the 455.
>> Jim Hupy
>> Salem, Oregon
>>
>> On Thu, Jun 9, 2022, 7:48 AM Keith V wrote:
>>
>>> I have a non Toro 455 with a bad block, the cly bores are very rusted,
> it
>>> would need to be sleaved.
>>> it has c heads, not sure if it has the good valve covers, not a Toro
>>> intake, crank may be OK
>>>
>>> I'm planning on selling the heads and valve covers unless they are the
>>> good one and scrapping the rest
>>>
>>> is there anything else I should salvage?
>>>
>>> Keith Vasilakes
>>> Mounds View MN
>>> 76 exRoyale
>>> MicroLevel>> http://www.gmcmotorhomemarketplace.com/vasilakes/microlevel_intro.pdf>
>>>
>>>
>>> _______________________________________________
>>> GMCnet mailing list
>>> Unsubscribe or Change List Options:
>>>
>> _______________________________________________
>> GMCnet mailing list
>> Unsubscribe or Change List Options:
>>
>
>
> --
> Jim Kanomata ASE
> Applied/GMC, Newark,CA
> jimk@appliedairfilters.com
> http://www.gmcrvparts.com
> 1-800-752-7502
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
>
--
Bruce Hart
1976 Palm Beach
LaGrange, Wyoming
GMC=Genetically Modified Chevy
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
Bruce Hart
1976 Palm Beach
1977 28' Kingsley
La Grange, Wyoming
|
|
|
[GMCnet] Re: Olds 455 donor engine [message #369964 is a reply to message #369963] |
Wed, 15 June 2022 18:33 |
jimk
Messages: 6734 Registered: July 2006 Location: Belmont, CA
Karma: 9
|
Senior Member |
|
|
Starter is on the driver side and mounts to the block.
Toronado mounts on the trans on the passanger side,
Oilpan needs to be for the Toro,
On Wed, Jun 15, 2022 at 2:55 PM Bruce Hart wrote:
> If it is a non Toro and not from a GMC isn't the starter mounted on the
> driver's side?
>
> On Thu, Jun 9, 2022 at 11:02 AM Jim Kanomata
> wrote:
>
>> Valve covers are valuable, intake manifold,
>> Jim Kanomata ASE
>> Applied GMC RV
>>
>>
>> On Thu, Jun 9, 2022 at 7:52 AM James Hupy wrote:
>>
>>> Yes, the cam gallery plug on the rear of the block. It has a lube hole
> to
>>> lube the distributor drive gear. Specific to the 455.
>>> Jim Hupy
>>> Salem, Oregon
>>>
>>> On Thu, Jun 9, 2022, 7:48 AM Keith V wrote:
>>>
>>>> I have a non Toro 455 with a bad block, the cly bores are very
> rusted,
>> it
>>>> would need to be sleaved.
>>>> it has c heads, not sure if it has the good valve covers, not a Toro
>>>> intake, crank may be OK
>>>>
>>>> I'm planning on selling the heads and valve covers unless they are
> the
>>>> good one and scrapping the rest
>>>>
>>>> is there anything else I should salvage?
>>>>
>>>> Keith Vasilakes
>>>> Mounds View MN
>>>> 76 exRoyale
>>>> MicroLevel>>>
> http://www.gmcmotorhomemarketplace.com/vasilakes/microlevel_intro.pdf>
>>>>
>>>>
>>>> _______________________________________________
>>>> GMCnet mailing list
>>>> Unsubscribe or Change List Options:
>>>>
>>> _______________________________________________
>>> GMCnet mailing list
>>> Unsubscribe or Change List Options:
>>>
>>
>>
>> --
>> Jim Kanomata ASE
>> Applied/GMC, Newark,CA
>> jimk@appliedairfilters.com
>> http://www.gmcrvparts.com
>> 1-800-752-7502
>> _______________________________________________
>> GMCnet mailing list
>> Unsubscribe or Change List Options:
>>
>
>
> --
> Bruce Hart
> 1976 Palm Beach
> LaGrange, Wyoming
> GMC=Genetically Modified Chevy
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
>
--
Jim Kanomata ASE
Applied/GMC, Newark,CA
jimk@appliedairfilters.com
http://www.gmcrvparts.com
1-800-752-7502
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
Jim Kanomata
Applied/GMC
jimk@appliedairfilters.com
www.appliedgmc.com
1-800-752-7502
|
|
|
Goto Forum:
Current Time: Sat Oct 12 08:23:28 CDT 2024
Total time taken to generate the page: 0.05228 seconds
|