Rear Bogie Pin Greasing [message #371244] |
Tue, 28 March 2023 13:00 |
Tom Katzenberger
Messages: 399 Registered: June 2019 Location: Kingsville, MD
Karma:
|
Senior Member |
|
|
Gentlemen,
When greasing the bogie pins is it best to remove one zerk and flow the grease consistently from one Zerk and out the removed Zerk?
We do this on aircraft props so that we are always flushing out to old grease and also not over pressuring the seals. Greasing is always done in the same direction year after year so that the grease always flows in the same direction (old out, New in)
Thanks for any thoughts.
Take care,
Tom K.
Tom & Oki Katzenberger,
Kingsville, Maryland,
1977 23' Birchaven, 455 C.I.D., Micro Level, Howell EBL-EFI Spark Control, Macerator, York Air Compressor, 6 Wheel Disc, Quadra Bag, Onan W/Bovee Ignition
|
|
|