[GMCnet] Re: Tach wire [message #370066] |
Sun, 03 July 2022 13:14 |
James Hupy
Messages: 6806 Registered: May 2010
Karma: -62
|
Senior Member |
|
|
That "tach" connector in the HEI cap was for the Handy Dandy GM diagnostic
console used in the dealerships. These were made/marketed by Kent-Moore to
authorized GM dealerships only.
Independent Garages had to make do with Snap-On, or other vendors
for those big expensive machines. I have used both kinds, and they all have
specific good and bad points. There are hand held devices today that do
much the same tasks on modern stuff. We use software programs for laptops
for the EFI stuff as well.
Jim Hupy
Salem, Oregon
On Sun, Jul 3, 2022, 11:04 AM Nelson Wright wrote:
> Emory
> I may be wrong, but I don’t remember any factory GMC MH tachometer , so
> there wouldn’t be a wire.
> Nelson
> 78 Royal rear bath
> Belle isle Fl & Nantahala NC
>
> Sent from my iPad
>
>> On Jul 3, 2022, at 1:49 PM, Emery Stora via Gmclist gmclist@list.gmcnet.org> wrote:
>>
>> I know the tach wire goes to the end of the distributor but I cannot
> find it. Can someone tell me the color?
>>
>> It is not shown in the wiring diagrams.
>>
>> Emery Stora
>> emerystora@mac.com
>>
>>
>> _______________________________________________
>> GMCnet mailing list
>> Unsubscribe or Change List Options:
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
|
|
|