Digi-Panel Calibration? [message #355361] |
Tue, 02 June 2020 18:28 |
Christo
Messages: 109 Registered: April 2019 Location: Weymouth, MA
Karma:
|
Senior Member |
|
|
I just replaced a broken engine temp sensor on my PO-installed Digi-Panel, and as with the old sensor (before it broke) the temp reads about 25 degrees low. My estimate is based on a reading from an IR thermometer pointed at the sensor which is attached to one of the thermostat bolts. My analog gauge reading (non-stock) is comparable to the IR reading.
Can the Digi-Panel temp reading be calibrated, or is there some other common issue that might cause this symptom? Maybe a dirty connector at the back of the Panel or something?
Christo Darsch
GMC Nor'easters
1977 Eleganza II - "The Komet"
3.50 Power Drive, Disc Brakes, Alcoas
Weymouth, MA
|
|
|