| In-Tank Fuel Pump Wiring [message #248904] |
Wed, 30 April 2014 15:24 |
Jon payne
Messages: 495
Registered: May 2008
Karma: 1
|
Senior Member |
|
|
Guys,
I'm wiring up my in-tank fuel pumps I got from Applied. The leads on the pump are not long enough to reach the base of the fuel sender so I have to extend the leads. At first I was going to use the wire I have but the coating is PVC which I believe will not tolerate being submerged in fuel. I do have some PTFE wire, left over from an aircraft wiring mod, but I think it is only 22 gauge. Searching the innerweb I see all kinds of opinions on what kind of wire to use, some say PVC is fine others say it is not. I have read PVC is fuel resistant but not necessarily made for submersion.
Looking for some opinions/advice on what to do for the in-tank wiring.
Jon
Jon Payne
76 Palm Beach
Westfield,IN
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
